| HOME | PRODUCTS | LITERATURE | APPLICATIONS | WARRANTY | CONTACT US |
|
|
| ||||||
|
|||||||
|
The vacuum regulator mounts directly on the cylinder valve by means of a positive yoke type clamp having an integral tightening screw with slide bar handle. No wrenches or other tools are required to mount or dismount the vacuum regulator from the cylinder. The cylinder valve/inlet valve adaptor is constructed of corrosion-proof fluoroplastic material which is inert to the effects of wet, dry or liquid chlorine, sulfur dioxide or ammonia. The inlet/safety shut-off vacuum regulating valve is of a capsulated design, easily removable as a unit from the outlet side of the yoke. A flouroplastic filter is installed in the vacuum regulator inlet and is capable of removing impurities greater than 25 microns. A pressure relief valve is incorporated into the vacuum regulator to prevent pressure from building up in the system. All external screws and nuts are made of titanium to prevent corrosion.
The vacuum regulator is securely clamped onto the gas cylinder valve. Water under pressure flows through the ejector at high velocity which causes a strong vacuum to be create. This opens the check valve in the ejector assembly and transmits a vacuum signal through the remote meter tube/rate valve panel and back to the vacuum regulator. When the vacuum reaches a pre-set level, the diaphragm in the regulator moves to open the chlorine inlet safety valve, permitting gas to flow from the chlorine cylinder. the spring-opposed diaphragm and inlet valve regulate the vacuum at this point. |
Chemical Injection Technologies, Inc.
4796 South US 1
Fort Pierce, FL 34982
Phone: 772-461-0666
Fax: 772-460-1847
superior@chlorinators.comHome | Products | Applications | Warranty | Company | News | Contact
Standard CL2